2010 International WorkStar 7600 T/A Sanding Truck UNRESERVED

-Has Key: Yes-Running Condition: Starts And Runs-GVWR: 66,000 lbs-Front Axle Capacity: 20,000 lbs-Rear Axle Capacity: 23,000 lbs-Wheelbase: 550-Engine-HP: Cummins 10.8L-Transmission: Automatic w- Clutch Eaton-Mileage (Showing Unverified): 257,986 km-Hours (Showing Unverified): 5,093 Hours-Sander: Yes-Backup Alarm-Air Conditioning-Cruise-Aluminum Rims-Steel Rims-Tire Size, Front: 425-65R22.5, Rear: 11R22.5-Additional Details, Batttery Disconnect Switch, Rexroth Controls, Tenco 5 30 25 0005 Box-Not Test Driven-Damages, Rust, Dents – Scratches Throughout, Driver Fuel Tank Step Missing-Registration History, Previously MB Registered or Permitted, Requires MB Certification, Registration Has Not Been Provided-hr, All payments must be made in full before the item(s) can be released to the purchaser. Please note that all sales are final on this auction sale. Please be advised the purchaser is held accountable for the item(s) within their purchased lot(s). The purchased lot(s) must be completely removed from its location when picked up by the purchaser. Failure to comply to the above requirements results in a mandatory disposal fee. From the time this unit arrived at McDougall Auction-s sale location, McDougall Auction verified its specific running condition. Please note there may be minor wear and tear, such as dents, scratches, etc. that are not disclosed in this listing. There is no guarantee, representation, or warranty that the vehicle will start, run at idle, or regarding its current registration status at the time of pick-up from McDougall Auction-s facility. It is the purchaser-s sole responsibility to ascertain, confirm, research, inspect, and-or investigate the unit prior to bidding. Once the unit has been removed from McDougall Auction-s sale location, the purchaser accepts the unit -as is.